Dobrý den, přívod studené vody a vývod teplé vody je nahoře? Na obrázku to není vidět Děkuji
AUCTIONEERS OKC 200
Boiler 200 l - combined, vertical, hanging, power consumption 2200 W, ceramic heating element type, max. water heating temperature 80 °C, insulation thickness 42 mm, energy efficiency class C, noise level 15 dB(A), energy consumption 4403 kWh/annum, features exchanger, magnesium anode and temperature indicator, degree of protection (IP rating) IP44, dimensions 130 × 58.4 × 58.4 cm (H × W × D)
Show full description
-17 % off new
13,790,-
New 16,815,-
Installment calculator
4,9%
interest
from 317,- monthly
Shop faster with pickup at AlzaBox or in-store.
Warranty 12 months
Code:
FAC6000b4
Product Fiche
Producer's Website:
AUCTIONEERS OKC 200
13,790,-
Slightly used - in stock 1 pcs
Buy
AUCTIONEERS OKC 200
AUCTIONEERS OKC 200 is fully functional and is a great value. It may have some signs of wear, but it is still ready for immediate and full use. We provide half of a standard warranty period. For more detailed information, click here.
Combined storage heater with a volume of 195 litres designed for wall hanging. It is suitable for hot water preparation in buildings with gas or solid fuel central heating in the winter season and heating with electricity outside the heating season using low electricity tariff (night current). The manufacturer has maintained the same 450 mm anchor bolt spacing throughout the production history, so it is no problem to replace it with an old, retired heater.
Heating options:
Electricity:
Ceramic heating element controlled by an operating thermostat and protected by a safety thermostat (thermal fuse). Temperature range 5-74 degrees Celsius. Connection voltage 1-PE-N/AC 230 V/50 Hz. Electrical protection IP 45 allows the heater to be placed in zone 1 according to ČSN 33 2000-7-701.
Exchanger:
The heater can be connected to an external hot water source with max. temperature of 110 degrees Celsius and pressure of 1 MPa. Depending on the power of the source, it is necessary to match the heater with the appropriate power of the heat exchanger. The exchanger operates in both forced circulation and in a stand-alone system. The heating water control sensor can be placed in a common sump with the wiring sensors.
Information on warranty and claiming defects:
Parameters and specifications:
Volume:
195 l
Maximum operating pressure of the vessel:
0,6 MPa
Tension:
230V
Power consumption:
2200W
Electrical coverage:
IP 45
Heater height:
1300 mm
Heater diameter:
584 mm
Maximum weight of the heater without water:
81 kg
Electric heating time from 10 °C to 60 °C:
5.5 hours
Maximum operating overpressure of the heat exchanger:
1 MPa
Temporal area:
0,68 m2
Nominal heat output at a heating water temperature of 80 °C and a flow rate of 310 l/hr:
9000 W
Exchanger heating time from 10 °C to 60 °C:
86 min
Nominal heat output at a heating water temperature of 80 °C and a flow rate of 720 l/hr:
17000 W
Exchanger heating time from 10 °C to 60 °C:
45 minutes
Thermal losses:
1.4 kWh/24 hours
Energy efficiency class:
B
Heating options:
Electricity:
Ceramic heating element controlled by an operating thermostat and protected by a safety thermostat (thermal fuse). Temperature range 5-74 degrees Celsius. Connection voltage 1-PE-N/AC 230 V/50 Hz. Electrical protection IP 45 allows the heater to be placed in zone 1 according to ČSN 33 2000-7-701.
Exchanger:
The heater can be connected to an external hot water source with max. temperature of 110 degrees Celsius and pressure of 1 MPa. Depending on the power of the source, it is necessary to match the heater with the appropriate power of the heat exchanger. The exchanger operates in both forced circulation and in a stand-alone system. The heating water control sensor can be placed in a common sump with the wiring sensors.
Information on warranty and claiming defects:
- The device requires professional installation. If the device is not installed by a professional company (after verification with the manufacturer, an invoice from the installer is sufficient), it loses the warranty.
- In the event of a boiler defect, the boiler MUST NOT be taken down, servicing is done onsite.
- In the case of an unjustified claim (even a defect that does not manifest itself), the customer is charged for the trip.
Parameters and specifications:
Volume:
195 l
Maximum operating pressure of the vessel:
0,6 MPa
Tension:
230V
Power consumption:
2200W
Electrical coverage:
IP 45
Heater height:
1300 mm
Heater diameter:
584 mm
Maximum weight of the heater without water:
81 kg
Electric heating time from 10 °C to 60 °C:
5.5 hours
Maximum operating overpressure of the heat exchanger:
1 MPa
Temporal area:
0,68 m2
Nominal heat output at a heating water temperature of 80 °C and a flow rate of 310 l/hr:
9000 W
Exchanger heating time from 10 °C to 60 °C:
86 min
Nominal heat output at a heating water temperature of 80 °C and a flow rate of 720 l/hr:
17000 W
Exchanger heating time from 10 °C to 60 °C:
45 minutes
Thermal losses:
1.4 kWh/24 hours
Energy efficiency class:
B
Specifications
Location
Mounting method
Type of heating
Maximum water heating temperature
Heating housing tyoe
Location
Location
Mounting method
Heating
Type of heating
Maximum water heating temperature
Heating housing type
Heating housing tyoe
Features
Features
Degree of protection IP
Insulation thickness
Energy specifications
Energy efficiency class
Noise
Energy consumption
Volume
Volume
Volume for gen. categories
Volume for gen. categories
Power consumption
Power consumption
Dimensions
Depth
Width
Height
More Specifications
Note:
Specifications can be changed without notice. Images are for illustrative purposes only.
