Solight wireless doorbell, 250m, black, learning code

The black design of the Solight wireless doorbell with clean lines looks unobtrusive and elegant, while at the same time blending in subtly with most interiors and not disturbing the overall appearance of the room. One wireless doorbell just needs to be plugged into a regular socket, no drilling or pulling cables required. A range of up to 250 metres in open areas ensures trouble-free operation. The doorbell offers a choice of 58 melodies, 4 types of signaling and 5 volume levels. The "learning code" encoding allows you to add multiple bells or buttons to a group and eliminates interference from other bells in the vicinity.

Pairing function "Learning code"

The "Learning code" function allows you to pair several bells or buttons into one group or to restore the connection between them. You can use several buttons to ring one bell or one button to ring several bells. Each transmitter can be paired with an unlimited number of
receivers.

Ringer connection 1:
Plug into a 230 V AC power socket.

Connection and installation of the transmitter:
Press the flathead screwdriver into the joint on the short side and open the back cover. Using your finger or a flathead screwdriver, release the latch also on the short side and tip the inner cover to the side. Open the seal protecting the battery from moisture penetration. Replace the 3V CR2032 battery and observe the marked polarity. Then close the gasket and both covers carefully. Before attaching the transmitter, make sure the wireless connection is working properly where you want to use it. The transmitter is waterproof and can be placed outdoors. Prefer a place protected from water and excessive heat. The transmitter can be mounted on the pad using double-sided self-adhesive pads or screws with dowels, without or with a protective canopy.

Ringer control:
Select the melody using the melody selection button, see picture above. Press the button to play and change individual melodies. The option is automatically saved when playback is finished. To select the volume, use the volume button, see picture above. You can choose from five volume levels. To set the ring mode, briefly press the multi-function button. You can choose from four modes (chime only, flash only, chime and flash, chime and continuous light. The continuous light mode also serves as a night light.

Warning:
Prevent improper handling of this appliance and always follow the electrical appliance usage policy. Designed for use in the home or indoors. Do not expose the receiver (doorbell) to environments with high humidity (e.g. bathroom), avoid contact with liquids.

Transmission frequency:
433 MHz

Power button:
1× 3V CR2032 battery (included)

Power bell:
AC 230 V - for socket

Operating temperature button:
-10 °C to +40 °C