APC Smart-UPS 1000VA LCD RM

The backup power supply APC Smart-Ups 1000 VA displays important data directly on the front panel on a clear LCD. With extra navigation keys, you can also conveniently configure the UPS unit. The device supports remote management of the unit through a computer network. You can also use the USB port or the serial interface.

Companies looking for energy efficiency will appreciate a patented operating mode that bridges unused electrical components in good power conditions and thus achieves very high operating efficiency without any reduction in the protection. The unit also shows the actual number of kW hours used so you can easily verify the power consumption of the connected devices. Unwanted grid load is then eliminated by active PFC correction. Of course, the device is also highly efficient with 97% at full load, effectively eliminating unwanted heating. The unit is an independent group of sockets that can be controlled independently of the UPS and can be used to perform a separate restart of connected devices and switching on or off.

An automatic voltage regulation and Boost and Trim (AVR) provide higher application availability by correcting low or high voltage conditions without discharging the battery. You will save money thanks to an intelligent charging voltage control system, depending on the battery temperature, which significantly prolongs its service life. Regular battery testing also ensures timely detection of the need for replacement. The unit provides surge protection during current surges, spikes or lightning and other power irregularities. It also automatically starts the connected devices after the power is restored.

Parameters and Specifications:

Output:
Maximum adjustable power: 700W/1000VA
Rated output voltage: 230V
The nominal output voltage can be set to 220, 230 or 240 V
Efficiency at full load: 97%
Output voltage distortion: less than 5% at full load
Output Frequency (Synch. With network): 57-63Hz, nominal frequency 60Hz

Output Connections:
4x IEC 320 C13
2x IEC Jumpers

Input:
Rated input voltage: 230V
Input frequency: 50/60 Hz +/-3Hz (autodetection)
Input connection type: IEC-320 C14
Input voltage range: for power supply from the grid
160-286V
For power supply from the grid you can adjust the input voltage range:
151-302V

Battery and run time:
Maintenance-free, sealed lead-acid accumulator with suspended electrolyte (not flowing)
Typical charging time: 3hrs
Number of battery modules: 1
Runtime: runtime graph / display runtime

Communication and administration:
Port interface: RJ-45 Serial, SmartSlot, USB
Quantity of SmartSlot: 1
Control panel: A multifunctional LCD status and control console
Audible Alerts: Battery Status / Clear Low Battery / Adjustable Time Warning
Emergency shutdown: optional

Overvoltage protection and filtration:
Shock Energy: 459J
Filtration: continuous multipole noise filter / IEEE surge arrester 0.3% / zero key response time / corresponds to UL 1449

Design:
Black Colour
Dimensions: 89 x 432 x 457 mm (H x W x D)
Weight: 28.18kg

Packaging includes:
Software CDs, Documentation CDs, Installation Guide, Rack Mount Supports, RS-232 Smart-UPS Signaling Cable, USB Cable