METALAC Taurus Max 200-2i, 200L, 2× exchanger, stainless steel
METALAC Taurus Max 200-2i, 200L, 2× exchanger, stainless steel
The METALAC Taurus Max 200-2i is an indirect water cylinder without a heating element. It connects to an external heat source, such as a gas boiler, electric boiler, fireplace insert with an exchanger, solid fuel boiler, photovoltaic power plant, or a heat pump. It has two exchangers and one or two heating rods. When hot water is required, the 3-way valve switches and the heat source begins to heat the water via the heating rod located inside the cylinder. It can heat water to a temperature of 75°C in 120 minutes. It offers protection against corrosion using a magnesium anode and thicker insulation, which ensures lower heat loss.
Key features of the METALAC Taurus Max 200-2i, 200L, 2× exchanger, stainless steel water cylinder
- Indirect water cylinder without a heating element
- Connects to an external heat source such as a gas boiler, electric boiler, fireplace insert with an exchanger, solid fuel boiler, photovoltaic power plant or heat pump
- Features two exchangers and one or two heating rods
- Heats water to 75°C in 120 minutes
- Offers corrosion protection and thicker insulation for lower heat loss
- The METALAC Taurus Max 200-2i cylinder boasts a large exchanger surface area and a virtually inexhaustible supply of hot water
- The package also includes 2 stainless steel coils
The METALAC Taurus Max 200-2i cylinder boasts a large exchanger surface area
The METALAC Taurus Max 200-2i cylinder boasts a large exchanger surface area and a virtually inexhaustible supply of hot water. Compared to an electric heater, the heat source can heat the same amount of water in a fraction of the time. The cylinder has a maximum operating pressure of 0.6MPa, the output of the upper heat exchanger in continuous mode at 60–80°C is 17kW and the output of the lower heat exchanger in continuous mode at 60–80°C is 34kW. The package also includes 2 stainless steel coils.
Recommendations before wall mounting:
Before mounting, you must check the load-bearing capacity of the wall and, depending on the type of masonry, choose a suitable anchoring material or reinforce the wall if necessary. Due to the different types of load-bearing masonry and the wide range of special anchoring materials available on the market, the manufacturer does not supply this material with the heater. The anchoring system must be chosen individually, according to the specific conditions. We recommend that wall mounting and anchoring be entrusted to a professional company.
Specifications
Location
Heating
Heating housing type
Features
Energy specifications
Volume
Volume for gen. categories
Dimensions
MAREX TRADE s.r.o., K Šeberáku 180/1, 14800 Praha- 4 Kunratice, [email protected], +420 607 032 153
Specifications can be changed without notice. Images are for illustrative purposes only.
