
The Termofol underfloor heating mat consists of a system of wires laid on a special fibreglass mesh. The installation does not raise the floor level and provides the pleasant feeling of a warm floor, which also increases the comfort of any interior. A constant output of 150W/m² ensures optimal thermal parameters, and the system itself is in no way dependent on the existing central heating installation, so it can be controlled independently. The H6-Wifi ready-made installation kit is designed for self-installation.

Heating mat application:
1. Cement screed
2. Heating mat
3. Adhesive for underfloor heating or self-levelling compound
4. Ceramic tiles / parquet / stone
Structural preparation and assembly:
The first step in laying the mat is to create an opening in the wall for two pipes to accommodate the end of the power cable and the sensor wire. A Ø 60 flush-mounted box for installing the temperature controller must also be placed in the wall. Then, you can proceed with laying the system on the floor. For the underfloor heating mat to serve its purpose, it must be spread evenly over the entire floor area. It is particularly important to maintain equal spacing and to avoid downpipes, sewer drains, hot water installation elements or heating pipes. In the event of a fault and the need to replace these elements in the future, mechanical damage to the wires could occur. It is not advisable to lay the heating mat so that it runs between separate rooms or under permanently installed furniture or equipment. However, it is permissible to lay it under wall-hung sanitary ware or furniture on legs. The electrical wires must never be shortened. If the heating foil or heating mat under the panels, terracotta or floor covering is too long and does not fit in the room, only cuts to the mesh may be made.
Specifications can be changed without notice. Images are for illustrative purposes only.